Steps to program a 28-pin Micromite chip with the forware for the Voltage/Current/Resistance reference:

1) load SCVoltCurRef_Library.bas
2) execute LIBRARY SAVE command
3) set up ILI9341 graphics
4) set up touchscreen
5) load SCVoltCurRef_Main.bas
6) execute AUTORUN ON command

Additional notes:

1) The articles list an incorrect range of resistance for resistance reference mode. The actual range is approximately 3500-24000 ohms, with relatively few choice above 10000 ohms.
2) As will be explained with an erratum in the April 2017 issue, the three resistors connected to pin 5 of IC6B (47, 2200 and 47000 ohms) should be changed to 220k, 10Megohms and not installed respectively, in order to provide better accuracy in current reference mode.
